Roll a Blunt

1. Bite off the tip of the blunt. Scrape out the tobacco. You now have your blunt casing.

2. Make a good slice down the middle of the blunt (length wise). Gently (very!) Crack the cigar with either your thumbnails or razor blade starting at the open end.

3. Peel the outside layer of tobacco off the blunt. If you leave the outside layer on, it tends to have an unpleasant taste. Lick the ends of the blunt paper. Wave it in the air, so it'll dry.

4. Break up the weed you're going to use. Take out all seeds and stems.

5. Next, spread the weed around evenly in the casing leaving some space at each side. Curve the casing gently around so you do not lose any tobacco or damage the casing itself. Lick one of the inner sides as to make an adhesive (sticky) tab. Roll it up! The final thing to do is lick the seam and dry it with a lighter by bringing the flame back and forth across the seam. Or, you can dry it by putting it in the microwave for about ten seconds. Be careful when using the lighter method, you don't want to burn the side of the blunt.

6. Smoke it up! One blunt is equivalent to about five joint.